These step-by-step instructions will assist you in setting up and connecting your Hyperfibre ONT & modem to your Fibre 4000 broadband connection.

Connecting your computer to the modem

1. Plug an ethernet cable into one of the LAN ports on the modem and plug the other end into your computer. If your computer is capable of a 4000Mbps connection, please use LAN 10G. All other LAN ports support up to 1Gbps connection.

Rebooting the modem

There is an ON/OFF button at the back of the modem on the left hand side to reboot the modem.
Or you can do it inside the interface:

1. Connect the yellow Ethernet cable from one of the free LAN ports on your modem to the Ethernet plug on your computer as shown below.
2. Open your web browser (Internet Explorer, Google Chrome, Mozilla Firefox or Safari) and type in the address bar 192.168.1.254, then press ‘Enter’ on your keyboard.
3. A box will appear requesting a Username and Password. Try the details below:
   1. Username: userAdmin
   2. Password: This information is located on the bottom of your modem.

4. Click on Maintenance > Reboot Device

Factory Reset the modem

There is a RST hole next to WLAN button to factory reset the modem to default settings.
Or you can do it inside the interface:

1. Connect the yellow Ethernet cable from one of the free LAN ports on your modem to the Ethernet plug on your computer as shown below.
2. Open your web browser (Internet Explorer, Google Chrome, Mozilla Firefox or Safari) and type in the address bar 192.168.1.254, then press ‘Enter’ on your keyboard.
3. A box will appear requesting a Username and Password. Try the details below:
   1. Username: userAdmin
   2. Password: This information is located on the bottom of your modem.

4. Click on Maintenance > Factory Default